WEATHER GUARD Model 252-3-02 EZ-GLIDE® System, Full-Size, GM - Manual (Page 5)

STEP 1
Use the supplied lubricant and coat the pre-assembled
Black Plastic Bushing (A). Insert Rear Drive Tube/Handle
Assembly (B) into the larger Black Plastic Bushing (C) in
the Rear Cross-Member Assembly (D) so that the black
bushings are fully seated.
(A)
(B)
(C)
(D)
STEPS 2 & 3
Slide a White Plastic Bushing (A) onto the Rear Drive Tube (B) until it is
butted up to the Cross-Member (C). Align holes in the tube and bushing.
Slide the Pivot Arm (D) over the tube and bushing, align holes, and install
the 3/8-16 x 2-1/4" Fastener. Next install the 5/16-18 x 4-1/4" Fastener
with four Flat Plastic bushings (E) as shown.
(A)
(B)
(D)
* 3/8-16 x 2-1/4"
Hex Hd. Bolt
(2) 3/8" Flat
Washer
3/8-16 Nylon
Lock Nut
5/16-18 x 4-1/4"
Hex Hd. Bolt
(2) 3/8" Flat
Washer
5/16-18 Nylon
Lock Nut
(E)
STEP 4
Place the Ladder Support (A) on top of
the Connecting Tube (B) and install the
5/16-18 x 2-3/4" Fastener.
(A)
(B)
5/16-18 x 2-3/4"
Hex Hd. Bolt
(2) 5/16" Flat
Washer
5/16-18 Nylon
Lock Nut STEP 5
Place the Ladder Stop (A) on top of the Cross-Member (B)
and install the 5/16-18 x 2-1/2" Fastener (Flat Hd. Screw).
(A)
(B)
5/16-18 x 2-1/2"
Flat Hd. Screw
5/16" Flat
Washer
5/16-18 Nylon
Lock Nut
(C)
5
NOTE: Tighten all marked (*)
fasteners to 200 in. lbs.
NOTE: Large Black Plastic Bushings
are keyed to fit the Cross-Members