V.I.O. POV.1 - Manual (Page 38)

38 POV.1 Recorder
•
•
•
•
•
•
The C-clamp fixture has a large screw-pin in the bottom that is used for
holding the fixture in place on the base mount. This system allows you to
remove the C-clamp fixture and camera head from the base mount while
leaving the base mount in place, which is handy if the base mount is
permanently attached to something.
This is also useful in cases where you use several base mounts aligned for
different video shots and wish to move the camera head from one mounting
location to another for each different shot.
To mount the C-clamp on one of the base mounts you need to remove the
screw-pin from the C-clamp, slide the fixture over the base mount rail so the
screw-pin will be aligned with the groove in the rail, and then insert the
screw-pin and tighten it to hold the C-clamp in place.
To mount the wide flange base mount you have several options. The plate
has screw holes in each corner so that it can be screwed down to hold it in
place. It also has grooves along all four sides to provide more flexibility in
mounting the base. You can also use these grooves to feed straps through,
and then strap the base mount down to a flat surface.
The wide flange base mount can also be used with one of the included
adhesive patches:
• a wide flange adhesive patch with a foam pad
• a wide flange Hook and Loop patch with an adhesive backing
The wide flange adhesive patch is useful for places where you want to
permanently mount the flat plate base mount, and the wide flange Hook and
Loop patch is useful for applications where you want to be able to remove
and replace the base mount from a certain location.
The tubular rail base mount is designed to be held in place with either a zip
tie (included with the POV.1) or a strap (not supplied with the POV.1).
The zip tie or strap can be fed through the slots located at the bottom of the
base mount. This mount can be attached to the handlebars of a bicycle,
motorcycle, snowmobile, jetski, etc. using straps or zip ties.