Set subnet mask, Set ip address, Set time – V.I.O. Stream User Manual
Page 52
STREAM User Manual
52
<system>
<status>Running</status>
<version>v1.5039</version>
<serialnumber>ETP-1234-00001</serialnumber>
<ipaddress>172.16.197.197</ipaddress>
<time>1373912804</time>
<utc>-7</utc>
<user>none</user>
<password>none</password>
</system>
Note that each item may be retrieved individually instead of as a group. For instance
/api/system/time will retrieve only the time.
set subnet mask
/api/system/subnet=255.255.255.252
Sets the subnet for the IP over USB interface. This should be changed before
the IP address. Once the IP address changes, the change takes effect.
set IP address
/api/system/ipaddress=172.16.197.197
Sets the IP address for the USB interface. Once this command is sent the IP
address will change and the camera needs to be re-booted.
set time
/api/system?time=1373912804
Sets the system time in EPOCH.
set utc (timezone)
/api/system?utc=-8
Sets the Universal time code (UTC/GMT) for local time
set user
/api/system?user=foo
set password
/api/system?password=bar
Note that after setting a username and password, all subsequent requests must utilize HTTP basic
authentication
reset to defaults
/api/system/defaults
Resets the system settings to the default manufacturers configuration
save settings
/api/system/settingssave
Saves the new setting configuration to memory so that these settings will be
used until either they are changed by command or the reset to defaults is