Leica Geosystems RCS1100 Series - Manual (Page 24)

24 Operation RCS1100-1.2.0en
5
The instrumentation is set up and
prepared in the same way as the
TPS1100. The keyboard and display
differ somewhat from those in the
other series and so a keyboard
template must be used with the
RCS1100. The presentation in the
RCS1100 of the dialogues from the
TPS1000 differs slightly, but this
does not in any way restrict the
operation.
The functions specific to the RCS
are described in detail in the
appropriate section of the user
manual for the TPS1000.
The greatest differences are in the
display of the icons; this is due to the
different dimensions of the display.
The time, and the battery status of
the TPS1000, are displayed
alternately in the title line.
Working with the TPS1000 series
Instead of two lines of three status
fields, one line of four status fields is
displayed on the right-hand margin.
1. The first position normally shows
the status for the memory card.
The operating mode is not shown,
because remote control is only
possible in RCS mode.
2. The second position normally
shows the telescope face. If the
compensator cannot be read out
at this time, the current display of
the telescope face is
superimposed. If the compensator
has been switched off, the
symbols for the compensator and
for the telescope face are
displayed alternately.
3. The third position shows the
status symbol for the automatic
target recognition (LOCK).
4. The last position shows the key
mode.
Hold for min. 2 seconds.
Complete display
The complete contents of the
respective display is transfered if the
display is incomplete due to
disturbances to the radio link. The
function is only available on the
RCS.