Channel Plus 5115BID - Manual (Page 3)

Connecting A Video Source
Using any video source, DVD,Satellite or VCR connect it to the wall
plate as shown. This video source will be transmitted over the Cat 5
wire to the channel injector.
Use the NORM / LOOP switch to select the proper setting for your
application.
NORM:
Select NORM when a television or a/v receiver is not used at the wall
plate to view the connected source.
LOOP:
Select LOOP when a television or a/v receiver is connected to the
wall plate to view the connected source
5
© 1999
Audio/video
connections
Cat 5 wire
Coax jumper
Out to
TVs
Optional loop
out television
or a/v receiver
Antenna or
CATV feed
Video source
Norm/Loop
switch
*
*
Installation of the wall plate
Step Two
The wall plate mounts using a low voltage ring into a wall cut out.
Run a line of Cat 5 wire from the wall plate to the channel injector
and connect wires as shown.
note:
When using quad wire connect
wires only to pins 1, 2, 5 and 6.
Leave the resistor in place
at pins 3 and 4.
At the channel injector, connect Cat 5 wire as shown. Follow the
color coding on the screw terminal.
Bl/W
Blue
Org/W
Orange
Gr/W
Green
Br/W
Brown
Green
Red
Black
Yellow
pin
1
2
3
4
5
6
7
8
4
Default
resistor
pin
1
2
5
6
note:
When using Cat 5 wire
remove the default resistor
that is in pins 3 and 4 of the
wall plate screw terminal
Side view
of wall plate
blue/white
pin 1
When using only quad wire
use positions 1, 2, 5 and 6
and follow color coding.
© 1999
run the Cat 5 wire
through the grommet at the
bottom of the injector
blue/white
pin 1