Steffes 8188 - Manual (Page 14)

Step 6 Remove the top two screws from the damper bracket
at the center of the damper assembly (Figure 5A).
Rotate the damper actuator assembly 90 degrees
(Figure 5B) to keep it out of the way when attaching
the Storage Module(s) to the Air Handler.
Step 7 Remove the 7/8" (inner) knockout on the limit access
panel (Figure 3) on the side(s) of the Air Handler
where the Storage Module(s) will be attached.
Step 8 Move the Storage Module(s) within 6" of final position to Air Handler. Once
in place, adjust the leveling legs on the bottom of the Storage Module(s) as
necessary to prevent rocking. If not placed properly the system may bend
or twist during the brick loading process, causing alignment problems during
re-assembly.
DO NOT extend the leveling legs more than 1".
Step 9 Locate the orange limit switch wires in the limit area of the Storage
Module(s). Secure the connector located on these limit switch wires into the knockout on the limit
access panel (Figure 6).
Step 10 Making certain that the orange limit switch wires between the Air Handler and Storage Module(s) are
routed properly, move the Storage Module(s) into their final location next to the Air Handler. The edge
of the side L brackets on the Air Handler MUST fit inside the S-Clip brackets on the side(s) of the
Storage Module(s). (See Figures 7 and 8.)
I NSTALLATION
„
3.05 T HERM E LECT
Installation
FIGURE 6
FIGURE 5
A B
Risk of Improper Operation and
Equipment Damage. Improper routing
of the limit switch wires can result in
improper operation or equipment dam-
age. DO NOT physically damage or
route the limit switch wires near high
temperature areas. When attaching the
Storage Module to the Air Handler make
sure the limit switch wires are not
pinched or cut. When routing the limt
switch wires inside the Air Handler,
make sure they are routed through the
pre-installed plastic cable ties.
CAUTION
FIGURE 7
FIGURE 8
FIGURE 4
A B C
Step 5 Securely mount the damper(s) to the Storage Module(s) using the screws provided in the outlet damper
kit. Two screws are required for each side of the damper assembly (Figures 4A and 4B); four screws
are inserted along the top and four screws are inserted along the bottom of the damper. To insert the top
screws, open the damper as shown in Figure 4C.