Cisco 3825 - Manual (Page 223)

A-91
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
show l2tp session
show l2tp session
To display basic information about all active L2TP sessions, use the show l2tp session command in the
user EXEC mode.
show l2tp session
Syntax Description This command has no arguments or keywords.
Command Modes User EXEC
Command History
Usage Guidelines Use the show l2tp session command to display information about all active sessions using L2TP.
Examples The following is sample output from the show l2tp session command on a device with active L2TP
sessions:
Router# show l2tp session
L2TP Session Information Total tunnels 1 sessions 4
LocID RemID TunID Username, Intf/ State Last Chg Uniq ID
Vcid, Circuit
9547 61932 2220 100, AT0/0: est 2w6d 1
9580 61966 2220 1100, AT0/1:0/100 est 2w6d 21
9584 61970 2220 1200, AT0/1.1: est 2w6d 29
9595 61981 2220 1101, AT0/1:0/101 est 1w0d 37
Router#
Related Commands
Release Modification
12.1(1)T This command was enhanced to display Point-to-Point Protocol over
Ethernet (PPPoE) information.
12.1(2)T This command was enhanced to display PPPoE session information on
actual Ethernet interfaces.
12.4(12)MR2 This command was integrated into Cisco IOS Release 12.4(12)MR2.
Command Description
show l2tp domain Displays all VPDN domains and DNIS groups configured on the NAS.
show l2tp group Displays a summary of the relationships among VPDN groups and
customer/VPDN profiles, or summarizes the configuration of a VPDN
group including DNIS/domain, load sharing information and current
session information.
show l2tp history failure Displays the content of the failure history table.
show l2tp multilink Displays the multilink sessions authorized for all VPDN groups.