California Faucets Single Hole/Handle Bidet Faucet - Manual

INSTALLATION
INSTRUCTIONS
SINGLE HOLE-SINGLE HANDLE BIDET FAUCET
IMPORTANT
All California Faucets products are engineered to provide quality performance provided they
are installed and operated properly. To fully enjoy the comfort, safety, and reliability of your new
Single Hole-Single Handle Bidet Faucet, please follow the instructions below.
6204
***NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
1
-Screw flex lines into body,
(one long & one short)
tighten with adjustable
wrench until stop. Do not
over tighten.
-Make sure sealing washer
is fitted into body base ring.
-Place bidet faucet base ring over
hole in bidet/top, with
sealing washer face down
and center.
-Insert lift knob/lift rod into
slot at back of bidet faucet
body.
-Place bidet faucet body assembly
on faucet base ring, inserting
flex lines, mounting rods and lift
rod through hole in bidet
top.
-Center bidet faucet on hole.
Fig. 1
Flex Lines
(one long &
one short)
Fig. 2
Fig. 3
Meets A112.18.1 (Min. 2.4 gpm)
Sealing
Washer
Body
Base Ring
Fig. 5 Fig. 4
Base
Ring
Mounting
Rods
Front View Side View
2
4 3
Lift Knob
Faucet Bidet/top
Hole
Lift Rod
Body
Lever
Handle
Spout
Lift Knob
Base Ring
Body
Faucet Bidet/top
Hole
Lift
Rod
Flex Lines
Swivel
Aerator
Install flex lines: Position base ring/sealing washer:
Insert lift knob/lift rod: Install assembly:
Two Components
Recommended
Hole Size:
1 3/8"
Tel: 714-891-7797
Fax: 714-891-2478
Toll Free: 800-822-8855
www.calfaucets.com
R
California Faucets reserves the right to make modification and specification changes at any time.
Please visit www.calfaucets.com for most current technical data.
Ref. 6204-INSTL (V 01) 02/28/06 Continued