California Faucets Widespread Lavatory Faucet - Manual

8" - 16" CENTERS
1"
"A" MIN
HOT SIDE COLD SIDE
1/2" NPSM
1/2"X3/8"X12"
FLEX LINE
72 & 73 Series
Fig. 1
71 Series
SPOUT
BASE
NOTCHED
WASHER
NUT
SHANK
RUBBER
WASHER
TEE
ROD
KNOB
O-RING
Fig. 2A
SPACER
HOUSING
KNOB
O-RING
Fig. 2B
FLOW
RESTRICTOR
INSTALLATION
INSTRUCTIONS
***NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
-Remove TEE, NUT, and notched WASHER.
-Insert SPOUT thru center hole of sink/countertop.
-Slip notched WASHER over spout SHANK.
-Align notch for lift ROD to pass thru then thread
NUT onto the spout SHANK.
-Align SPOUT and tighten NUT firmly.
-Place rubber WASHER into top of TEE and tighten
assembly onto spout SHANK.
-Attach lift KNOB onto lift ROD and slide O-RING up.
-Insert lift ROD down through spout BASE.
1
Install spout and lift rod with lift knob:
WIDESPREAD FAUCETS
IMPORTANT
All Widespread faucets meet A112.18.1 - 2.2gpm/8.3 L/min.
www.calfaucets.com 800-822-8855
R
#7102
#7202
#7302
7102-INSTL_081120 P1
(71, 72, & 73 Series)
FOR 71 SERIES (See Fig. 2A)
FOR 72 & 73 SERIES (See Fig. 2B)
-Remove TEE, HOUSING, NUT, WASHER and SPACER.
-Insert SPOUT thru center hole of sink/countertop.
-Slip SPACER and notched WASHER onto spout
SHANK. Align notch for lift ROD to pass through then
thread NUT onto the spout SHANK.
-Align SPOUT and tighten NUT firmly.
-Place rubber WASHER into top of restrictor HOUSING
and tighten assembly onto spout SHANK.
-Place rubber WASHER into top of TEE and tighten
assembly onto restrictor HOUSING.
-Attach lift KNOB onto lift ROD and slide O-RING up.
-Insert lift ROD down through spout BASE.
"A" = 1"
"A" = 1"
"A" = 3/4"
THROUGH-HOLE
SPOUT: 1-1/8"
VAVLE: 1"
THROUGH-HOLE
SPOUT: 1-1/4"
VAVLE: 1"
THROUGH-HOLE
SPOUT: 1-1/4"
VAVLE: 1"
Due to the thin wall tubular design of this spout, please note the following:
Spout is not meant to be used as a support or grab device. Any excessive weight, pulling or grabbing of spout may
cause damage or injury and will void the warranty.
It may be necessary to initially operate at full flow, then reduce the flow to retain the desired “sheet” flow effect at
lower operating water volume (72/73 /series only).