California Faucets Single Hole Low Lavatory Faucet - Manual

CF-E201-1_ii_140201.doc Pg 1
CF-E201-1
Single Hole Lavatory Faucet with Pop-Up Drain
Installation Instructions
1
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure: 20 to 70 psi *
* If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).
INSTALLING FAUCET TO SINK/DECK
• Insert O-RING (2) into bottom of BODY (1) and center
over sink/deck THROUGH-HOLE (3)
NOTE: Recommended sink/deck THROUGH-HOLE is Ø1-3/8”
• Insert FLEX HOSE (5) (one at a time) and THREADED
ROD (4) though sink/deck THROUGH-HOLE (3)
• From underside of sink/deck THROUGH-HOLE (3),
place MOUNTING BRACKET (6) and NUT (7) onto
THREADED ROD (4)
• Align BODY (1) so that spout is centered into sink
• Tighten NUT (7) until BODY (1) is secure to sink/deck
• Insert lift ROD (8) through hole on backside of BODY
(1) and slide down through deck
• Position O-RING (9) on ROD (8) so that lift KNOB
(10) does not hit backside of BODY (1)
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
BY A LICENSED PROFESSIONAL