California Faucets Solima Widespread Faucet - Manual

CF-7002_ii_110914.doc Pg 1
Solimar
™
CF-7002
Widespread Lavatory Faucet
Installation Instructions
1
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure: 20 to 70 psi *†
Maximum Flow Rate: 1.5 gpm
* Operating pressures between hot and cold supplies should vary no more than 30 psi.
† If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).
INSTALLING SPOUT TO SINK/DECK
• Sink/Deck recommended hole size shall be Ø1-3/8”
• Place O-RING (3) into BASE (2) and sliding BASE
(2) onto spout SHANK (1a)
• Insert spout SHANK (1a) though sink/deck hole
• Slide small O-RING (5) about half way down onto
LIFTROD (4). (this will allow liftrod to be in place
for mounting, but not interfere with tightening of
spout hardware)
• Slide LIFTROD (4) through rear hole of BASE (2)
• From underside, place SLOTTED WASHER (6)
onto spout SHANK (1a) and tighten SPOUT (1)
into place with NUT (7)
• Insert RUBBER WASHER (8) into TEE (9) and
attach to spout SHANK (1a). TEE (9) should be
tighten to create watertight seal and positioned to
allow ease of attachment of valve hoses
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
BY A LICENSED PROFESSIONAL
Ш
1-3/8”