California Faucets Deluxe Arm for Large Showerheads - Manual

SH-570_ii_120119.doc Pg 1
Solimar
™
SH-570
Shower Arm
Installation Instructions
1
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure: 20 to 70 psi †
Flow Rate (at 60 psi): 10 gpm
† If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).
INSTALLING SHOWER ARM
• Prior to installing shower are in-wall fittings and
rough valve must be properly installed and wall
surface must be completely finished
• Recommended through-hole size shall be Ø1-1/4”
• Apply thread sealant to both threaded ends of
NIPPLE (2), not supplied, and tighten into
supported ELBOW (1)
, not supplied
IMPORTANT: QUICK CONNECT (3) must sit inside wall 5/8” min
to 1” max, to properly secured SHOWER ARM (6) to QUICK
CONNECT (3). This may be achieved by selecting proper NIPPLE (2)
length.
• Securely tighten QUICK CONNECT (3) onto end
of NIPPLE (2) using I/2” open-end wrench
• Place O-RING (4) into ESCUTCHEON (5) & slide
ESCUTCHEON (5) onto QUICK CONNECT (3)
IMPORTANT: To prevent damage to internal o-ring on SHOWER
ARM (6), QUICK CONNECT (3) must be free of any dirt and/or
debris
• Slide SHOWER ARM (6) onto QUICK CONNECT
(3), align ESCUTCHEON (5) & SHOWER ARM
(6) and tighten SETSCREW (7) on bottom side of
SHOWER ARM (6)
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
BY A LICENSED PROFESSIONAL
Ø
1-1/4”
Must sit inside wall
5/8” min to 1” max