Removing & emptying water bucket, Drain hose connection method – Whirlpool 1182182 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing & emptying water bucket
Drain hose connection method:
(to drain water from bucket continuously)
Bucket style 1
drain hose
connector cover
(not on all models)
1. If your dehumidifier does not have
a drain hose connector cover, go to
Step 2.
If your dehumidifier has a drain
hose connector cover, use a flat-
blade screwdriver to remove cover
from drain connector.Turn cover
counterclockwise. Discard cover. It
cannot be reused. Go to Step 2.
Bucket style 2
1. Slide off the drain hose connector
cover. Go to Step 2.
..
Do Not
damage
outside or
connection
will leak.
center of drain hose connector
2. Drill out only the center of the drain
hose connector. Use a minimum 1/4"
drill bit.
3. Attach a garden hose to drain hose
connector.The garden hose should
not be longer than 8 feet (2.4 m). Run
other end of garden hose into a floor
drain. Check that the hose lies flat
and in the drain.
To use the bucket without the garden hose:
For bucket style 1:
Use a garden hose cap to seal the drain
hose connector.
For bucket style 2:
Use a garden hose cap to seal the drain
hose connector.
Replace drain hose connector cover.