Flintec FT-16D V.1.21 - Manual (Page 23)

9 D IAGNOSTICS
The parameter block [9--] contains certain functions for checking and testing.
[9--] Diagnostics
The operations about checking and testing the instrument can be made here.
[90-] Tests
[900 ] Key Pad test
In this step each key’s ASCII code will be shown on the display as you press the related key. By this way
you can test if all the keys are functioning or not. Pressing “
↑” key will take you to the next parameter.
[904 ] mV Indication (for FT-16 only)
When pressing the <Enter> key the output voltage of the load cell will be shown on the display. This
uncalibrated value is only for test- and service purposes.
[905 ] DLC Internal Count (for FT-16D only)
When pressing the <Enter> key the message [905 1 ] is shown. The number of the load cell can be
selected by up and down keys and internal counts can be seen by pressing the <Enter> key.
Press the <F> key to quit this parameter.
[91-] Serial Numbers
[910] Instrument Serial No.
[911] Option 1 Serial No.
[912] Option 2 Serial No.
[913] Option 3 Serial No
When pressing the <Enter> key the serial number of the instrument or the option will be shown.
[97-] Calibration Coefficients (for FT-16 only)
The parameters located in this section are the calibration parameters of the instrument. If these values have
been noted this can help when a calibration problem occurs. You can refresh the calibration by entering the
correct values.
[99-] Printing Parameter Values
[990] Print All Parameters
By pressing the <Print> key all parameters can be printed.
[991] Loading Default Parameters
When pressing the <Enter> key the [ Ld dEf ] message appears on the display. Press the <Tare> key for
loading the default values or press the <F> key to go to “9-“ sub block.
FT-16(D) Technical Manual, Rev. 1.21 December 2008 Page 23 of 32