IC Realtime 2Mp Full HD 3x Network PTZ Dome Camera (ICIPP2000M4) - Manual (Page 11)

4
3 CEILING INSTALLATION
3.1 Installation Components
The ceiling installation dome body is shown as in Figure 3-1.
Figure 3-1
3.2 Ceiling Installation Steps
3.2.1 Installation Requirements
The ceiling mount speed dome can be installed in the hard construction wall in the indoor
environments. Before the installation, please make sure:
 The wall is thick enough to install the expansion bolt.
 The wall can at least sustain the 8x weight of the speed dome.
3.2.2 Installation Steps
1) The ceiling installation has two cable exit modes: One is to pull the cable through the
side cable exit of the speed dome without dig holes on the ceiling. The other is to dig
holes on the ceiling and pull the cable through the ceiling.
2) Confirm installation position and cable exit mode. Use the ceiling installation position
map to dig holes on the ceiling and then put the four plastic expansion bolts firmly.
3) In Figure 3-2, pull the cable according to your cable exit mode. And then use four
screws to secure the pedestal and driver of the ceiling speed dome on the ceiling. Turn
the screws to the plastic expansion bolts.
4) In Figure 3-3, use three screws (provided) to secure the external enclosure on the
pedestal and fix firmly,