Interlogix Concord 4 User Manual - Manual (Page 14)

12 Concord 4 User Manual
Note: Entry beeps are silenced after the first keypress. They will restart after
5 seconds with no key presses. You must enter your access code to
completely disarm the system.
• Disarm the system before opening a door or window while the system is
armed.
To arm to Level 1 using a keychain touchpad, press the Unlock button.
Level 2 (stay)
Use Level 2 to arm perimeter doors and windows only. Interior devices such as
motion sensors remain off so that you can stay inside the premises without
setting off an alarm. If you wish, you can exit through a designated delay door
after arming to Level 2. To arm to Level 2 using a touchpad:
1. Close all protected perimeter doors and windows.
2. Press 2 at any touchpad. Touchpads display ENTER CODE. (If the quick arm
feature is on, an access code is not required to arm the system to Level 2).
3. Enter your access code. Touchpads display ARMED TO STAY and the system
sounds two short beeps.
4. If you are leaving the premises, exit through a designated delay door
immediately.
To arm to Level 2 using a keychain touchpad, press the Lock button once to go
from Level 1 to Level 2.
Level 3 (away)
Use this level to arm perimeter door/window sensors and interior motion sensors
for maximum protection. To arm to Level 3 using a touchpad:
1. Close all protected perimeter doors and windows.
2. Press 3 at any touchpad.
Touchpads display ENTER CODE. (If the quick arm feature is on, an access
code is not required to arm the system to Level 3).
3. Enter your access code.
Touchpads display ARMED TO AWAY and the system sounds three short
beeps.
4. Exit through a designated delay door immediately.
To arm to Level 3 using a keychain touchpad, press the Lock button twice to go
from Level 1 to Level 3, or once to go from Level 2 to Level 3.