Interlogix IS-ZW-AM-1 - Manual

GE
Security
IS-ZW-AM-1 Appliance Module
Installation Sheet
Description
Z-Wave technology is designed to automate lighting/home control
and provides easy remote operation of all your Z-Wave enabled
devices. The GE Z-Wave family includes a variety of devices to
control lighting in your home.
This module is one device of a Z-Wave control system and is
designed to work with all other Z-Wave enabled devices in a home
control network. It will also act as a wireless repeater to ensure
that commands intended for another device in the network are
received, thereby extending the range of the wireless controller. Z-
Wave devices of other types can be added to the system and will
act as range extenders if they support this function of repeating
the signal received to other nodes in the system.
Note: This document assumes you have a remote control to enroll
the unit into your system. This document does not include
instructions on how to use an optional web portal to enroll the
unit. If you have a web-enabled system, contact GE Security.
© 2009 GE Security, Inc.
1 of 4
P/N 1069503 • REV A • ISS 16NOV09
Key features
• One Z-Wave controlled AC outlet. Remote on/off control via
the Z-Wave remote control. Manual on/off control with the
module pushbutton.
• One always-on pass-through AC outlet.
• Space efficient design does not block the lower outlet when
plugged in to the upper outlet of a duplex wall receptacle (this
assumes that the duplex receptacle is mounted with the
ground pin down). Plugs and cords for connected devices
route to the side allowing close placement of furniture.
• Grounded 3-wire power connection for safety.
Note: There are no user serviceable parts in this unit.
To reduce the risk of electric shock, this product has a grounding
type plug that has a third (grounding) pin. This plug will only fit into
a grounding type power outlet.
Caution: If the plug does not fit into the outlet, contact a qualifed
electrician to install the proper outlet. Do not change the plug in
any way.
Installation
The device plugged into the Z-Wave controller outlet on this
module must not exceed 600 W (incandescent); 1800 W (15A)
Resistive or ½ HP Motor. Total load capacity for both outlets is
1800 W (15 A) Resistive.
WARNING: Due to risk of fire, electrical shock and burns, exercise
extreme caution when using Z-Wave devices to control
appliances. Operation of the Z-Wave device may be in a different
room than the controlled appliance, also an unintentional
activation may occur if the wrong button on the remote is
pressed. Z-Wave devices may automatically be powered on due to
timed event programming. Depending upon the appliance, these
unattended or unintentional operations could possibly result in a
hazardous condition. For these reasons, we recommend the
following installation guidelines.
Installation guidelines
• Assign Z-Wave controlled appliances to device numbers 10 to
18 on the remote control. The likelihood of unintentionally
turning on the appliance will be reduced significantly because
the Shift button will need to be pressed before pressing
device numbers 10 to 18.
• Z-Wave devices controlling appliances should be removed
from the “All” control setting. Refer to the documentation
provided with the remote control.
• Do not include Z-Wave devices in groups or scenes if they
control appliances.
• Do not use Z-Wave devices to control electric heaters or any
other appliances, which may present a hazardous condition
due to unattended, unintentional, or automatic power on
control.
• Double check programming for accuracy before using the
module.
Caution: Not for use with medical or life support equipment.
Z-Wave enabled devices should never be used to supply power to,
or control the on/off status of medical and/or life support
equipment.