Crestron electronic PROAMP(I)-7X400 - Manual (Page 14)

PROCISE™ Surround Sound Amplifier Crestron PROAMP(I)-7X400
Connectors, Controls & Indicators
# CONNECTORS*,
CONTROLS &
INDICATORS
DESCRIPTION
1 NET LED (1) Amber LED, indicates communication with
Cresnet system
2 PWR 1 LED (1) Green LED, indicates power switch is
enabled and power is present at the upper
power input
3 RESET BUTTON (1) Miniature pushbutton, clears all channel
fault indications if condition is resolved
4 TEMP LED (1) Red LED, indicates an over-temperature
condition
5 PWR 2 LED (1) green LED, indicates power switch is
enabled and power is present at the lower
power input
6 FAULT LEDS (7) Red LEDs; indicate over-temperature,
over-current, over or under power supply
voltage, or DC offset condition on the
corresponding channel
7 CLIP LEDS (7) Amber LEDs, indicate a clipping condition
on the corresponding channel
8 SIGNAL LEDS (7) Green LEDs, indicate signal presence on
the corresponding channel
9 POWER (1) Toggle switch, removes power from the
amp and resets microprocessor
10 LAN (1) 8-wire RJ-45 with 2 LED indicators;
10/100BaseT Ethernet port;
Green LED indicates link status; Amber LED
indicates Ethernet activity;
Straight-thru LAN cable included for direct
connection to PSPHD
11 NETWORK/DIRECT (1) Slide switch, selects whether connection
to PSPHD is via LAN or direct connection
12 OVERRIDE/SETUP
(LED and button)
(1) miniature pushbutton and (1) red LED,
used for touch-settable ID (TSID) in
conjunction with Crestron Toolbox™ software,
for activating Override mode for testing, and
for pairing with PSPHD
13 NET (2) 4-pin 3.5mm detachable terminal blocks;
Cresnet slave ports, paralleled;
24: Power (24 Volts DC)
Y: Data
Z: Data
G: Ground
NOTE: The NET port does not supply or
consume power.
(Continued on following page)
8
• PROCISE™ Surround Sound Amplifier: PROAMP(I)-7X400
Operations Guide – DOC. 6976A