Intex WL3110 2012 User Manual
Page 6
155
PO
SAVE THESE INSTRUCTIONS
Page 6
(155PO) POOL LIGHT ENGLISH 7.5” X 9.25” PANTONE 295U 11/18/2011
English
SSEE
TTUU
PP
II
NN
SSTT
RR
UU
CC
TTII
OO
NN
SS
&&
SS
TTOO
RR
AA
GG
EE
SETUP INSTRUCTIONS (continued)
Installation on Intex Sequoia Spirit Wood-Grain Pools:
Unscrew the bolts from the section where the LED pool-wall light will be installed,
and remove the clamp covers, the top board and the side boards. Refer to the
Wood-Grain Pool owner’s manual for details. For better installation, it is
recommended to remove at least 3 side board panels. Follow above setup
instructions 1 to 4.
LONG TERM STORAGE
In areas where freezing temperatures occur, there is risk of ice damage to the
product. It is recommended to remove, clean and store the product in a safe
place when temperature drops below 0 degrees Celsius (32 degrees
Fahrenheit).
1. Unplug the power cord from the electrical socket.
2. Remove the transmitter (2) from the outside of the pool wall first, the pool
light (1) unit will automatically float to the surface for easy retrieval, then remove
the pool light from the water.
IMPORTANT: To prevent damage to the transmitter from falling to the
ground, always remove the transmitter first before removing the pool light
unit.
3. If deposits or debris are seen inside the holes of the pool light, use a garden
hose to flush them out. Do not scrape the pool-wall light or use brush to clean it.
4. Thoroughly air-dry all components before storage.
5. Store the product and accessories in a dry, temperature controlled location
between 32 degrees Fahrenheit (0 degrees Celsius) and 104 degrees
Fahrenheit (40 degrees Celsius).
6. The original packaging can be used for storage.
4
5