Jaypro Sports PB-90 - Manual (Page 2)

REV- 2/2/2011
JAYPRO SPORTS
27’ PLAYER’S BENCH WITH BACK REST, PB-90
LIST OF MATERIALS
PIECE NO. PART NO. DESCRIPTION QTY.
1 AR5044 Bolt Clip With Slot 20
2 AR5045A End Cap 4
3 HB5030 Carriage Bolt 5/16”-18 X 3” 20
4 HN5046
5/16” Flange Nut
20
5 HS5035
#8 Pan Head Screw x ½”
8
6 EP0018
2” End Cap
20
7 AR5111 Seat Plank x 27’ 2
8 PB801 Leg 5
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Screwdriver Bit With Electric Drill (1),
½” Socket Wrench or Adjustable Wrench (1)
1) Slip the end caps (2) snugly onto each end of each plank (7). Using the electric
drill, assemble a self-drilling screw (5) through the cap and into the flange of the
plank. Two screws are required per end cap. Carefully assemble 2” end caps (6)
into bench legs (8).
2) For easiest assembly, position seat plank (7) on a level raised surface such as a
desk top, bleacher seat or work bench. Place the carriage bolt (3) and bolt clips
(1) approximately into place within the slots of the plank. Note that the outside
legs should be no more than 8” from the plank edge.
3) Position the legs (8) as shown and loosely assemble the hardware illustrated in
detail ‘A-A’. Do not fully tighten the hardware at this time.
4) Stand the unit upright and assemble the backrest plank (7) as illustrated. Level
the bench and make sure the legs are adequately spaced apart. Tighten all
fasteners fully.