Leitz Diamaster WhisperCut - Manual (Page 10)

Deuts
ch
English
中
文
Ita
liano
Fr
ançaise
Espa
ñol
Po
rt
uguê
s
Ру
сс
кий
10 04/2012 ID.524571 V2.0
Damaged tools have to be checked by an expert.
Danger of injuring from parts flying off.
Tools with cracked bodies or deformed seating of the cutting parts have to be taken out of
service. Repairing such tools is not allowed!
Danger of tool breakage.
Do not use a deformed tool.
1.5 Cleaning and Maintenance
1 chip area
2 Clearance face
For reasons of working safety, the cutting tip / cutting edges (see section “Servicing,
modifying, sharpening”) at the latest have to be serviced when:
- the wear mark width VB on the cutting edges amounts to more than 0,2 mm – pay
special attention to the main wear zones.
- break outs of the cutting edge are visible.
- the power consumption of the machine increases noticably.
Wear safety gloves!
Danger of injury by sharp cutting edges!
The cutting edges have to be regularly cleaned from resin and glue (built-up edges) – this
increases the performance time and the operational safety.
Protect hands and eyes while cleaning.