Leslie Controls AIR WHISTLES - RS Type, Single Tone and Chime Tone - Manual (Page 2)

Page 2 of 6
INTRODUCTION
This Installation, Operation, and Maintenance Manual is
intended to be as complete and up to date as possible. It covers
installation, operation, and maintenance procedures for Leslie
Controls, Inc. RS TYPE AIR WHISTLES control module.
Leslie reserves right to update this manual and other product
information concerning installation, operation, and/or
maintenance, at any time and without obligation to notify
product owners of such changes.
Leslie is not responsible for inaccuracies in specifications,
procedures and/or content of other product literature, supplied
by manufacturers of components used with Leslie Controls,
Inc. RS TYPE AIR WHISTLES Leslie strives to use only
highest quality components; however, LESLIE has no direct
control over their manufacture, or their consistent quality.
Leslie is not responsible for injury to personnel or product
damage due to improper installation, operation, and/or
maintenance Leslie Controls, Inc. Air Whistles. All
installation, operation, and maintenance procedures should
only be performed by trained/certified personnel. All
personnel performing these procedures should completely and
carefully read and understand all supplied materials before
attempting procedures. All personnel should pay strict
attention to all Notes, Cautions, and Warnings that appear
within procedures detailed in this manual.
Leslie welcomes user input as to suggestions for product or
manual improvement.
Contact Information
For information concerning warranties, or for questions
pertaining to installation,
Operation or maintenance of LESLIE products, contact:
LESLIE CONTROLS INC.
12501 Telecom Drive
Tampa, FL 33637
USA Phone: (813) 978-1000
USA Fax: (813) 978-0984
www.LESLIECONTROLS.com
To order replacement parts, contact LESLIE CONTROLS at
address listed above, or call toll free:
USA/Canada/Caribbean Phone: (800) 323-8366
Note: Please include model and serial number of unit for
which parts are being ordered. If ordering by phone, please
have this information readily available.
GENERAL NOTES AND WARNINGS
Notes:
•
If questions are not answered by this manual, or if
specific installation, operation, and/or maintenance
procedures are not clearly understood, contact Leslie
Controls, Inc. for clarification before proceeding.
•
If unit is damaged during installation, operation, or
maintenance, complete following steps:
1. Turn off and lock out pneumatic supply to unit in an
approved manner.
2. Turn off all incoming valves.
3. Contact in-house maintenance personnel or Leslie
Controls, Inc. for instructions.
Note: Throughout this manual, warnings will be denoted by
BOXES
All documentation for each major component has been
included with unit. It is strongly recommended that each
document be reviewed before attempting any installation,
operation, or maintenance procedures.
Documentation for each major component may also contain
warnings and cautions identified by manufacturer of each
component. These warnings and cautions may be specific for
particular component, and therefore not covered in this general
Installation, Operation, and Maintenance Manual. They should
also be carefully reviewed before attempting installation,
operation, or maintenance procedures.
CAUTION!
Piping system must be adequately designed and
supported to prevent extraordinary loads to pressure
equipment.