MF Digital DIRECTOR EC OFFICE PUBLISHER WITH Spectrum2 PRINTER - Manual (Page 2)

Installing the Firewire Adapter & Software Identifier Cards
You should never attempt to service a unit without ensuring proper anti-static protection. The
use of a grounding strap, or other such grounding device, is advised. In addition, the internal
configuration of your computer may be different from the computer pictured below.
Note:
Installing the Firewire Card
The DirectorEC Office Publisher requires
one IEEE-1394 card.
1. Shut down the PC.
2. Turn the PC’s power off.
3. Unplug the PC.
4. Remove the PC’s cover as
indicated in the PC’s manual.
5. Locate an empty PCI slot, as
seen in (fig.1).
6. Install the firewire adapter card (fig. 2).
Installing the Software Identifier Card
a. If your PC is not OFF, perform the
Windows shutdown now.
b. Turn-off powers switch and unplug AC
power from the wall.
c. If the PC’s cover has been re-installed,
remove it now.
d. Locate an Empty slot, Mount the
Software Identifier card in slot as
illustrated (fig. 3).
e. Connect the 3.5” Floppy type power
cable such that the yellow wire is
facing out.
f. Using a 40 Pin EIDE cable, connect the
card to the Secondary IDE Channel on
your PC mother- board.
g. Be sure PIN 1(red wire) if facing
AWAY from the motherboard, and
next to the power connector on
software identifier card (fig. 3). (fig. 3)
(fig. 1) (fig. 2)
Page 2