Vertical Communications MP5000 User Manual
Page 11
CONVERSip EP300 User
May ‘04
Comdial
11
To adjust the pedestal, perform the following tasks.
1. Grasp the rear of the
pedestal base firmly
with one hand and
lift the rear portion
of the EP300
upward with your
other hand.
2. Lift the EP300
upward with one
hand and raise the
EP300 supporting
arms upward with
your other hand.
Notice there are
three sets of notches under the EP300 corresponding to the
three positions available.
3. When the EP300 is at the desired height, select the closest pair
of notches and insert the supporting arms in the notches. Press
down slightly on the EP300 until you feel the supporting arms
snap into place.
Also remember, as with any piece of electronic equipment, your
EP300 may be damaged by contact with liquids. So please try to
place the EP300 in an area that is free from the danger of spills.