Solvline Eddy - Manual (Page 14)

U-Boot 1.2.0 (Apr 3 2008 - 09:56:10)
DRAM: 32 MB
SST : 39VF3201
Flash: 4 MB
In: serial
Out: serial
Err: serial
End of Autonegotiation
Hit any key to stop autoboot: 0
U-Boot>
U-Boot>
setenv serverip 192.168.0.220
Setting IP address of host computer that tftp server is installed by user is this part.
In other word, after setting ip of server by 192.168.0.220, gateway :192.168.0.1, netmask : 255.255.255.0,
user will connect with computer directly by offered LAN cable and eddy.
If user changed ip information, it goes to default state by "defenv" order.
U-Boot>
U-Boot>
U-Boot>
saveenv
Å
Store the information that has been set.
Saving Environment to Flash...
Un-Protected 1 sectors
Erasing Flash...Erasing sector .done
Erased 1 sectors
Writing to Flash... .done
Protected 1 sectors
U-Boot>
install bootstrap eddy-bs-21c.bin
eddy-bs-21c.bin will be downloaded from default download folder to eddy to start restoration through upper order.
Please check twice the firmware name.
TFTP from server 192.168.0.220; our IP address is 192.168.0.223
Filename 'eddy-bs-21c.bin'.
Load address: 0x20000000
Loading: T #
done
Bytes transferred = 2032 (7f0 hex)
Erasing sector .done
Erased 1 sectors
Copy to Flash... .done
Un-Protected 1 sectors
Erasing Flash...Erasing sector .done
Erased 1 sectors
Writing to Flash... .done
Protected 1 sectors
U-Boot>
install bootloader eddy-bl-21c.bin
.
eddy-bl-21c.bin will be downloaded from default download folder to eddy to start restoration through upper order.
Please check twice the firmware name.
TFTP from server 192.168.0.220; our IP address is 192.168.0.223
14