Studio Electronics SE-1X User Manual
Page 18
Saving in version 0.73 will be the same except that the “SAVE TO” name
will not change to the BANK 5 name until either the bank switch or
encoder is moved.
Saving Patches from RAM to RAM
Press “save”, rotate the encoder and/or press the “bank” switches to
select desired location. Press save again, to complete the operation.
Any sound source can be sent through the SE-1s filter circuits via this
audio input. By plugging into the input the noise sound source is replaced
with you’re very own external sound sources. Use the noise mix level to
adjust. Any amount of level may be sent into this input. Check it doe:
higher levels will ultimately overload the filter input and distortion effects
shall occur. NOTE: to hear the external audio source, a MIDI note must be
sent and held or “pulsed”. It is only when a MIDI note is received, that the
unit’s envelopes can be triggered, in turn, causing the VCF/VCA
/LFOs/Ring-Mod to process (Read mangle) the signal. One can use the
mix levels to add or remove the SE-1X sound sources, if so desired.
So far we haven’t encountered any, but there might be one or two lurking.
If you experience any unusual operation, please let us know and we’ll
remedy.
New update information, bug fixes, and important info will be accessible @
studioelectronics.com (da web site). Downloads and/or direct e-mails of
system updates will be posted/sent as available.
Please feel free to contact us if you have any questions, or comments;