TL Audio EQ-2 - Manual (Page 4)

The Stereo mode switch is a powerful facility, enabling precise tracking of
equalisation between channels, with quick adjustment and no need to match settings
on two sets of controls. All of the EQ controls are ganged; i.e. Cut/Boost, Frequency,
Q and band in/out switching. The input and output gain controls, high and low pass
filters and overall EQ in/out switches retain individual channel operation for
maximum flexibility.
A solid state, electronically balanced output stage with outputs switchable for +4dBu
or -10dBu nominal output level completes the channel. The balanced signals are
terminated on metal XLR sockets, with unbalanced line level inputs and outputs
provided on 0.25” jack sockets.
Please read this manual fully before installing or operating the Equaliser.
PRECAUTIONS
The T L Audio EQ2 Parametric Valve Equaliser requires very little installation, but
like all electrical equipment, care must be taken to ensure reliable, safe operation. The
following points should always be observed:
- All mains wiring should be installed and checked by a qualified
electrician,
- Ensure the correct operating voltage is selected on the rear panel
before connecting to the mains supply,
- Never operate the unit with any cover removed,
- Do not expose to rain or moisture, as this may present an electric
shock hazard,
- Replace the fuse with the correct type and rating only.
Warning: This equipment must be earthed.