Vermont Casting IRHEDV32 - Manual (Page 21)

10003929
A3) RHEFA and RHEFP TRIMS
Glass
Frame
Louvre
Note:
Position brass trim top as
shown (small end up)
to prevent heat discolouration
Fig. 27
Fig. 28
1. Remove the front glass (see "Glass Frame Re-
moval" section).
2. Install support window trim channel, top and
bottom brass trim by using the shortest black
screw. (Fig. 43 & 44).
TRIM ASSEMBLY 3. Install bottom decorative plate by simply sliding it
under the unit floor. No fastening is required for
this installation (See Fig. 45). Be sure to remove
protective cover.
4. Install the bottom louvre assembly by fastening the
hinges with four screws to the pre-punched holes
in the cabinet.
5. Re-install the front glass.
6. Install the top louvre by using the hooks to hang it
in place.
KEY DESCRIPTION RHEFA RHEFP
1 Trim Window Top/Bottom 52624-AB 52624-PB
2 Plate Decorative Bottom 17597-AB 17597-PB
3 Top Louvre Assembly 57905 57905
4 Bottom Louvre Assembly 57906 57906
5 Hinge 52356 52356
6 Fateners Package (Not Shown) 57916 57916
ALL repair parts will be available from your local dealer.
When ordering, always give the following information: Model and serial number, part description with finish and part number;
TRIM REPLACEMENT PARTS LIST
Fig. 29
21
BOTTOM
DECORATIVE PLATE
1
2
3
4
6
5
TRIM-TOP
GLASS FRAME
TRIM-BOTTOM
screws
5