Verity Audio Tamino - Packing / Unpacking Instructions - Manual (Page 2)

1005 Saint-Jean-Baptiste, Suite 150
Quebec, QC G2E 5L1 Canada
Tel: (418) 682-9940
Fax: (418) 682-8644
www.verityaudio.com
[email protected]
2004.06.30
Tamino
P r o d u c t P a c k i n g I n s t r u c t i o n s
The packaging accessories are:
i. (2) 14" x 17" x 18" cardboard boxes;
ii. (2) Inner cardboard boxes;
iii. (2) Accessory
boxes;
iv. (4) Protective wooden boards;
v.
(2) Top / bottom protective foam covers;
vi. (2) Speaker grilles;
vii. (1) Package containing the owner’s manual
and registration card.
The Tamino loudspeakers are packed in cardboard boxes and
provides space for:
i. (2) Tamino loudspeakers;
ii. (2) Speaker grilles;
iii. (4) Accessory boxes.
Each accessory box contains:
i. (2) Connector posts;
ii. (4) Threaded spikes;
iii. (4) Threaded spike locking nuts.
1. Turn off the power amplifier(s);
2. Completely unscrew the four connector posts from the
Tamino loudspeakers and disconnect the speaker cables;
3. Remove all the threaded spikes and locking nuts from the
loudspeaker cones;
4. Store two connector nuts, four threaded spikes and four
locking nuts in each plastic case.
5. Wrap the Tamino loudspeakes in their plastic bags;
6. Lift a Tamino and insert it into the bottom foam cover,
then put the top foam cover on the loudspeaker;
7. Cover the speaker with the inner cardboard box;
8. Strap the outside of the inner cardboard box in order to
hold together the bottom foam cover, the inner cardboard
box, and the top foam cover;
9. Open the main cardboard and place it in its vertical
position. Follow the directions printed on the main
cardboard box;
10. Gently slide the inner cardboard box inside the main
cardboard box, the front of the loudspeaker facing the
opening;
11. Carefully lay the main cardboard box on its horizontal
position;
12. Place the four protective wooden boards inside the main
cardboard. One on each side and one on each extremity;
13. Slide one grille between the top foam cover and the main
cardboard. The grille’s studs should be pointing towards
the speaker and plunged inside the foam;
14. Slide the owner’s manual between the wooden board and
the main cardboard box;
15. Repeat steps 6 to 13 for the second Tamino;
16. Close the cover of both boxes and tape them adequately;
17. Strap both boxes;
18. The Taminos are ready to be addressed and shipped.