Viconics VRP5000 (Classic ZigBee) Installation Manual - Manual

0028-0265-04
1
www.viconics.com / [email protected]
Product overview
The VRP5000W1000W wireless repeater has been specifically designed to be used
within a Viconics wireless ZigBee network for Viconics wireless controllers.
The repeater is intended to be a low cost additional communication component used
when some remote controllers are too far from the main mesh of the Viconics device
cluster and cannot communicate with either:
• A VWG ( Viconics Wireless Gateway )
OR
• A JACE wireless communication card and related WirelessStatNetwork driver file that have been specifically designed to
be used by the Niagara AX ® powered JACE controllers.
The repeater(s) will enable the remote controller(s) to re-establish communication and act as bridge(s) to the main mesh.
The repeater(s) can be installed where most convenient such as a wall or in a suspended ceiling space if required.
VRP5000W1000W
24 VAC Powered Zigbee Repeater
For Viconics Wireless Networks Applications
(Issue Date May 3rd, 2012 – 028-0265-04)
VRP5000W1000W
Repeater
Viconics Controller(s)
Main Mesh Cluster
Remote Viconics
Controller(s) Cluster
The following documentation is available on www.viconics.com
• VWG hardware installation is available in document LIT-VWG-40-INSTALL-Exx
• VWG BACnet integration information is available in document ITG-VWG-40-BAC-Exx
• VWG information on design considerations of a wireless mesh network set-up and diagnostics is available in document
LIT-VWG-40-SETUP-Exx
• JACE2 communication card set-up, integration information and design consideration of wireless mesh networks for set-
up and diagnostics is available in document MAN-Wireless-Stat-Driver-Guide-Exx