Warning – Sears 153333531 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

-WARNING-

BEFORE

LICHUNG

[PROPANE

(LP.)

GAS

WATER

HEATERS]:

Propane

(L.P.)

gas

Is

heavier

than

air.

Should there be a leak in the system, the gas will settle
near

the

ground.

Basements,

crawl

spaces,

skirted

areas

under

mobile

homes

(even

when

ventilated),

closets

and

areas

below

ground

level

will

serve

as

pockets

for

the

accumulation

of

this

gas.

Before

attempting to light or relight the water heater's pilot or
turning on a nearby electncal light switch, be absolute­
ly sure there is no accumulated gas in the area. Search

for odor of gas by sniffing at ground level in the vicini­

ty of the appliance. If odor is detected, follow the steps

indicated at "For Your Safety" on the cover page of

this manual, then leave the premises.

Lighting and operating instructions are located on front of

the water heater, above or to one side of the gas control
valve

-WARNING

AN ODORANT IS ADDED TO THE GAS USED

BY THIS WATER HEATER,

FOR YOUR SAFETY
IF YOU SMELL GAS:
1. Do not try to light any appliance.

2. Do not touch any electrical switch; do not use any

phone in your building.

3. Immediately call your gas supplier from a neighbor's

phone, follow the gas supplier's instructions.

4. If you cannot reach your gas supplier, call the fire

department.

WARNING

DO NOT force the gas control knob. Use only your

hand to push it down to light the pilot, or to turn it to

"ON", "OFF" or "PILOT", Never use a tool such as a

lever, wrench or pliers- Do not hit or damage the knob.
A damaged knob may result in an explosion and seri­
ous injury. If you have problem turning the knob, call

the gas supplier immediately.

CHECK FOR LEAKS

Be sure to check afi your gas pipes for leaks before light­
ing your water heater Use a soapy water solution, not a
match or open flame. Check the factory gas fittings after
pilot is lit and gas control knob is still in "PILOT" position.

Then, check the fittings when the main burner is turned

"ON". Use a soapy water solution for this, too.

Figure 6

Figure 7

Figure 8

• * * * * — , , , ■■—-***^

I .....

Figure 9

INNER DOOR

OUTER DOOR

15

Advertising
This manual is related to the following products: