Clarity TELEPHONE W1000 - Manual (Page 16)

CLARITY W1000 16
OPERATING THE CLARITY W1000
phone base, next to the program button.
It should sign steady.
3. When placing a call, dial as you
would any phone and wait for someone
to answer.
4. Press the Boost Button
5. Adjust the Clarity Power Control up-
wards to a level where the other party’s
voice is heard loud and clear, and begin
conversation.
6. When you complete the call, return the
handset to the base unit.
7. After hanging up, the sound level will
reset to normal level.
8. Pressing the Boost Button during
subsequent conversations will return the
volume to your set sound level.
Note: If you made an error while dialing,
just depress the hookswitch, listen for a
dial tone, and dial again.
➤ Neck Loop/Auxilary Port
The W-1000 has a 3.5mm phono jack to
use with a neck loop. The volume to the
neck loop is controlled with the Clarity
Power Control. When the neck loop is
plugged in, the receiver in the handset is
disabled.
➤ Hearing Aid Compatibility
The Clarity W1000 is Hearing Aid Compat-
ible with hearing aids that utilize a
T- switch or T-coil.
Once you have installed your Clarity
W1000 according to the instructions noted
previously, it will be ready to use.
➤ To Place or
Receive a Call:
1. Adjust the Clarity Power Control to its
lowest setting (zero).
2. Pick up the handset and listen for the
caller’s voice or a dial tone. Watch the
green sound level light located on the