Port mirroring configuration, Rcload, Atca-n700 sw users guide – ADLINK aTCA-N700 User Manual
Page 56: Display mirrong status, Remove xe0 mirroring, Rcload’ executes switch command scripts
aTCA-N700 SW Users Guide
５０
RDBGC0.xe0
:
24,999,987
+0
R64.xe0
:
97,654
+0
R127.xe0
:
6,152,568
+0
R255.xe0
:
18,652,091
+0
R511.xe0
:
97,674
+0
RPKT.xe0
:
24,999,987
+0
RUCA.xe0
:
24,999,987
+0
RPRM.xe0
:
24,999,987
+0
RPOK.xe0
:
24,999,987
+0
RBYT.xe0
:
3,999,973,180
+0
T64.xe0
:
1
+0
T127.xe0
:
4
+0
T255.xe0
:
5
+0
TPOK.xe0
:
10
+0
TPKT.xe0
:
10
+0
TUCA.xe0
:
10
+0
TBYT.xe0
:
1,299
+0
PERQ_PKT(10).xe0 :
10
+0
PERQ_BYTE(10).xe0 :
1,299
+0
8.3.8. Port mirroring configuration
‘dmirror’ sets mirroring option for a selected portto a target port.
Usage (DMIRror): Parameters: <ports> [Mode=<Off|On|Ingress|Egress|All>]
[DestPort=<port>]
[DestModule=<modid>]
[DestTrunk=<tgid>]
[MirrorTagProtocolID=<tpid>]
[MirrorVlanID=<vid>
DestTrunk overrides DestModule/DestPort.
TPID and VLAN are set only if DestPort is a local port.
Port mirroring configuration examples are shown below.
** Mirror port xe0 ingress packet to xe3.
BCM.0> dmirror xe0 m=ingress dp=xe3
** Display mirrong status.
BCM.0> dmirror show
** Remove xe0 mirroring.
BCM.0> dmirror xe0 m=off
8.3.9. rcload
‘rcload’ executes switch command scripts.
Usage (RCLoad): Parameters: <file> [parameters]
Load commands from a file until the file is complete or an error
occurs. If optional parameters are listed after <file> they are
pushed as local variables for the file processing. For example:
rcload fred a bc will result in the variables:
$1
=
a
$2
=
bc
during processing of the file.
For platforms where FTP is used, the user name, password and host
may be specified as: "user%password@host:" as a prefix to the
file
name