Danby DAC10000 - Manual (Page 4)

Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
ELECTRICAL
SPECIFICATIONS
FOR YOUR SAFETY: Read these instructions carefully before operating the unit.
1) All wiring must comply with local and national electrical codes and must
be installed by a qualified electrician. If you have any questions
regarding the following instructions, contact a qualified electrician.
2) Check available power supply and resolve any wiring problems
BEFORE installing and operating this unit.
3) For your safety and protection, this unit is grounded through the power
cord plug when plugged into a matching wall outlet. If you are not sure
whether your wall outlet is properly grounded, please consult a qualified
electrician.
4) The wall outlet must match the 3-prong plug on the service cord
supplied with the unit. DO NOT use plug adapters. If it is necessary to
use an extension cord to connect your air conditioner, use an
approved “air conditioner” extension cord only (available at most
local hardware stores).
5) The rating plate on the unit contains electrical and other technical data.
The rating plate is located on the right side of the unit, above the power
cord.
3
POWER SUPPLY CORD NOTE: Your unit’s device may differ from the one shown.
This room air conditioner is equipped with a power supply cord required by
ULC. This power supply cord contains state-of-the-art electronics that
sense leaking current. If the cord is crushed, the electronics detect leaking
current and power will be disconnected in a fraction of a second.
To test your power supply cord:
1. Plug power supply cord into a grounded 3 prong outlet.
2. Press RESET (on some devices, a green light will turn on).
3. Press TEST (listen for a click; Reset button will trip, and on some
devices, a green light will turn off).
4. Press and release RESET (listen for a click; Reset button will latch, and
on some devices, a green light will turn on). The power supply cord is
ready for operation.
LCDI
TEST RESET
POWER
B A
ELECTRICAL
SPECIFICATIONS WARNING: To reduce the risk of fire, electrical shock or injury
when using your air conditioner, follow these basic precautions:
• Plug into a grounded 3 prong outlet.
• Do not remove ground prong.
• Do not use an adapter.
• Do not use an extension cord.
• Unplug air conditioner before servicing.
• Use two or more people to move and install air conditioner.