Dv Mark Galileo 15C - Manual (Page 6)

6
15) FSW – 1/4” STEREO jack for connecting a DUAL footswitch for activating the Boost and switching the Drive section on and off.
16) SPEAKER OUTS – There are two speaker out sections. The 8 ohm section (single jack) is connected to the internal speaker. The
4 ohm section (two jacks) should be used if your impedance totals 4 ohms: plug one 8 ohm external cabinet into one of these, and unplug the
internal speaker connection from the 8 ohm section and plug it into the other 4 ohm section jack. Or, unplug the internal speaker and connect
two external 8 ohm cabinets to these outputs. Check the impedance of your cabinet/s to make sure you connect to the correct output/s.
17) AC POWER SOCKET
– Make sure the unit is grounded; all three terminals of the AC power plug must be connected to avoid any
injury to the user or damage to the unit. DV Mark amps and combos are manufactured to be used in the country where they have been sold,
and are factory preset to that country’s voltage. So make sure you’re sending the correct voltage to your amp before you connect it to AC power.
REAR PANEL
INPUT
0 MAX
BASS MIDDLE HIGH GAIN
0 MAX
MASTER
0 MAX
RIVERBERO
0 MAX STANDBY BOOST
OFF
COMBO GALILEO 15
TOTAL 4 Ω
OR 8 Ω + 8 Ω 8 Ω
DO NOT OPERATE THIS
AMPLIFIER WITHOUT
CONNECTING LOUDSPEAKERS
0 MAX
15
16
17