EMM Labs Switchman MK II - Manual (Page 8)

Page 8 of 13
At this point, one of the LED indicators (1 to 6) is blinking to remind of the most
recently loaded template. Once new template is selected, the corresponding LED
indicator will light up. The LEDs will stay on for approx. 2 seconds and the system
returns to Volume Control Mode automatically.
New template settings are effective immediately; the Input System selector LED and
master volume display are updated.
The main rotary knob and TRIM button are inactive during template load operations.
1.2.4 Template Save Mode
Current system settings can be saved in a template. A template contains separate
data records for each Input System.
Press SAVE button to switch to Template Save Mode. Alternatively, press TEMP and
then SAVE keys to go to Template Save Mode.
Yellow LED indicators above TEMP and SAVE buttons should be lit. At this point you
can return to Volume Control Mode (press SAVE again) or select a template using
buttons
1
to
6
on the right side of the Remote. The System will wait for a template
selection for approx. 4 seconds. If a selector key is not pressed during that time, the
SwitchMan will return to Volume Control mode.
One of the LED indicators (1 to 6) blinks to remind of the most recently accessed
template.
When a template selector key is pressed, the corresponding LED indicator will light
up and the SAVE indicator will blink briefly to confirm the template save operation.
At this point, the current settings are already saved in the selected template in
NVRAM. Then SwitchMan system automatically returns to the Volume Control Mode.
The main rotary knob and TRIM button are inactive during template save
operations.