Hope Tech Integral Headset - Manual (Page 2)

44.1mm INTEGRAL HEADSET INSTRUCTIONS
Remove all sharp edges.
With 8mm allen key, adjust Head Doctor (items 12 to
16) until a slide fit inside steerer and insert it 10mm
into steerer.
Tighten until solid in steerer.
4/ FINAL ASSEMBLY :
Liberally apply good quality waterproof grease to all
bearings (4) and sealing surfaces. When fitting ensure
that the top seal (6) is fitted correctly.
Insert forks into frame.
Over the steerer, fit upper taper ring (5), shims (8) if
necessary, sealing cover (6) and top cover (7) with
o’ring (9). You may have to stack several 0.4mm shims
(8) to reduce the drag of the top seal (6).
Fit stem and top cap (10). Tighten bolt (11) in top cap
until forks rotate smoothly without play or restriction.
Clamp stem to manufacturer recommended torque.
The headset may need adjustment after the first few
rides, this is normal due to the settling of the compo-
nents.
1/ FITTING CUPS :
Firstly, ensure both ends of head tube are parallel and
of correct size. If necessary ream the bore and face each
end of the head tube.
Chamfer the inside edges of the head tube at both
ends.
Press in both cups (2 and 3) using a headset press
fitted with Hope adaptors. Note that both cups are
similar.
2/ FITTING CROWN RACE :
Slide the fork crown race (1) onto the steerer tube with
the flat side to the bottom. Then slide the bottom bear-
ing (4) on top of the fork crown race (1).
3/ CUTTING STEERER :
Fit forks into frame. Slide the complete top assembly
and stem over steerer. Ensure all parts are pushed
together firmly.
Scribe a line flush with the top of the stem.
Remove stem and cut steerer in a straight line 3mm
below the line.
44.1mm INTEGRAL HEADSET INSTRUCTIONS
Remove all sharp edges.
With 8mm allen key, adjust Head Doctor (items 12 to
16) until a slide fit inside steerer and insert it 10mm
into steerer.
Tighten until solid in steerer.
4/ FINAL ASSEMBLY :
Liberally apply good quality waterproof grease to all
bearings (4) and sealing surfaces. When fitting ensure
that the top seal (6) is fitted correctly.
Insert forks into frame.
Over the steerer, fit upper taper ring (5), shims (8) if
necessary, sealing cover (6) and top cover (7) with
o’ring (9). You may have to stack several 0.4mm shims
(8) to reduce the drag of the top seal (6).
Fit stem and top cap (10). Tighten bolt (11) in top cap
until forks rotate smoothly without play or restriction.
Clamp stem to manufacturer recommended torque.
The headset may need adjustment after the first few
rides, this is normal due to the settling of the compo-
nents.
1/ FITTING CUPS :
Firstly, ensure both ends of head tube are parallel and
of correct size. If necessary ream the bore and face each
end of the head tube.
Chamfer the inside edges of the head tube at both
ends.
Press in both cups (2 and 3) using a headset press
fitted with Hope adaptors. Note that both cups are
similar.
2/ FITTING CROWN RACE :
Slide the fork crown race (1) onto the steerer tube with
the flat side to the bottom. Then slide the bottom bear-
ing (4) on top of the fork crown race (1).
3/ CUTTING STEERER :
Fit forks into frame. Slide the complete top assembly
and stem over steerer. Ensure all parts are pushed
together firmly.
Scribe a line flush with the top of the stem.
Remove stem and cut steerer in a straight line 3mm
below the line.