Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 45781 Series - Manual (Page 15)

Chapter 3: Getting Started
Product Service 1-800-522-7658 11
If you have an Undercounter model, level it side-to-side by placing a short level
on the inside top edge of the door. See the figure below for the placement of the
level on the washer. Check the level front to back by placing a level on the rail
that the lower rack slides on.
Centering the Washer Door
When the washer is level, check the operation of the washer door for alignment
with the washer tank. If the door is not centered in the opening, you must center
the door by adjusting the corresponding leveling foot. (For example, if the door
hits the right side of the tank, raise the right front corner of the washer. If the
door hits the left side of the tank, raise the left front corner of the washer.)
Securing the Washer to the Countertop
If you have an Undercounter Glassware Washer, two screws have been provided to
attach the front of the washer to the underside of the countertop or work surface.
After the washer is leveled in its final position and the washer door is properly
centered, install the two screws as shown in the figure below to stabilize the unit
and prevent it from moving.