LEHR Eco Trimmer - Manual (Page 2)

LEHR | 2
LEHR ECO-TRIMMER
4-CYCLE PROPANE TRIMMER
For service call 1-866-941-LEHR in the United States, to
obtain a list of authorized service dealers near you.
For more details about your unit, visit our website at:
www.golehr.com.
DO NOT RETURN THE UNIT TO THE RETAILER.
PROOF OF PURCHASE WILL BE REQUIRED FOR
WARRANTY SERVICE.
THIS PRODUCT IS COVERED BY ONE OR MORE
U.S. PATENTS. OTHER PATENTS ARE PENDING
Service on this unit both within and after the warranty
period should be performed only by an authorized and
approved service dealer.
SPARK ARRESTOR NOTE
NOTE: For users on U.S. Forest Land and in the states
of California, Maine, Oregon, and Washington. All U.S.
Forest Land and the State of California (Public Resources
Codes 4442 and 4443), Oregon, and Washington require
by law that certain internal combustion engines operated
on forest brush and/or grass-covered areas be equipped
with a spark arrestor, maintained in effective working order,
or the engine be constructed, equipped and maintained
for the prevention of fire. Check with your state or local
authorities for regulations pertaining to these requirements.
Failure to follow these requirements could subject you to
liability or a fine. This unit is factory equipped with a spark
arrestor.
All information, illustrations, and specifications in this
manual are based on the latest production information
available at the time of printing. We reserve the right to
make changes at any time without notice.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTION BEFORE OPERATING
• Inspect the unit before use. Replace damaged parts.
• Check for fuel leaks. Make sure all fasteners are in place
and secure. Replace parts that are cracked, chipped,
or damaged in any way. Do not operate the unit with
loose or damaged parts.
• Carefully inspect the area before starting the unit.
Remove all debris and hard or sharp objects such as
glass, wire, etc.
• Be aware of the risk of injury to the head, hands and
feet.
• Clear the area of children, bystanders, and pets. At
a minimum, keep all children, bystanders, and pets
outside a 50 feet (15 m.) radius; there still may be a risk
to bystanders from thrown objects. Bystanders should
be encouraged to wear eye protection. If you are
approached, stop the unit immediately.
• Use only original equipment manufacturer replacement
line. Never use metal-reinforced line, wire or rope.
These can break off and become dangerous projectiles.
• Squeeze the throttle control and check that it returns
automatically to the idle position. Make all adjustments
or repairs before using unit.
• Do not operate this unit when tired, ill, under the
influence of alcohol, drugs or medications.
• This unit is intended for adult use only. Do not allow
children or untrained individuals to use the unit.
• Familiarize yourself with the controls and proper use of
your trimmer prior to using.
WARNING:
WHEN USING THE UNIT, YOU MUST
FOLLOW THESE SAFETY RULES. PLEASE
READ THESE TO ENSURE THE SAFETY OF
THE OPERATOR AND ANY BY ST ANDERS.
PLEASE KEEP THESE INSTRUCTIONS FOR
LATER USE.
WARNING:
WHEN SERVICING, USE ONLY
REPLACEMENT
IDENTICAL
PARTS. USE OF ANY OTHER
PARTS MAY CREATE A HAZARD OR CAUSE
PRODUCT DAMAGE.
SERVICE AND SAFETY
DU
• Never start or run the unit inside a closed room or
ing. Breathing exhaust fumes can be fatal. Operate this
unit only in a well ventilated outdoor area.
• Wear safety glasses or goggles that meet ANSI Z87.1
standards and are marked as such. Wear ear/hearing
protection when operating this unit. Wear a face or dust
mask if the operation is dusty.
• Wear heavy long pants, boots, gloves and a long sleeve
shirt. Do not wear loose clothing, jewelry, short pants,
sandals or go barefoot. Secure hair above shoulder
level.
• The cutting attachment shield must always be in place
while operating the unit as a trimmer. Do not oper
ate unit without both trimming lines extended, and the
proper line installed. Do not extend the trimming line
beyond the length of the shield.
• This unit has a clutch. The cutting attachment remains
stationary when the engine is idling. If it does not, have
the unit adjusted by an authorized service technician.
• Adjust the handle to your size in order to provide the
best grip.
• Be sure the cutting attachment is not in contact with
anything before starting the unit.
• Avoid accidental starting. Be in the starting position
whenever pulling the starter rope. The operator and
unit must be in a stable position while starting. Refer to
Starting/Stopping Instructions. (p.10)
• Only use this tool for its intended purpose.
• Do not overreach. Always keep proper footing and bal
ance.
• Always hold the unit with both hands when operating.
Keep a firm grip on both handles or grips.
• Keep hands, face, and feet at a distance from all mov
ing parts. Do not touch or try to stop the cutting attach
ment when it rotates.
parts get extremely hot from operation, even after the
unit is turned off.
SAFE OPERATION RULES
ALL RIGHTS RESERVED 2008-2009