Livorsi DTS Controls - Manual (Page 6)

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 6 of 12
Installing the Control to the Console
1. Secure the control to the console using 4 x #10 screws and nylon washers.
Neutral Safety Switch
The Livorsi DTS Control does not have a neutral safety switch. The start-in-gear
protection is controlled electronically by the propulsion control module (PCM).
a- throttle lever
b- trim switch
c- shift lever
Avoid possible corrosion damage. Always install a nylon washer between each screw
and the control plate. Improper installation may result in chipped paint, triggering
corrosion.
CAUTION
a- 4 x #10 screws screw (4)
b- Nylon washer (4)
c- Control quadrant assembly
d- Console
For an 8 handle control
o 6 x #10 screws
o Nylon washer (6)