Lumagen Radiance 2022/2042 - Manual (Page 9)

Section 2 – Overview
Radiance 2022 and Radiance 2042 rev 082813 3
Section 2 – Overview
Front Panel
The front panel has a light-emitting-diode (LED) indicator, which is red when the unit is in “standby” and, by
default, is green when the unit is “on.” Note: The green “on” indicator can be turned off if preferred.
Rear Panel
There are four HDMI and six analog video inputs. Audio can be received on the active HDMI input, one of
two analog stereo inputs, or one of five digital audio inputs (2 TOS, plus 3 COAX).
There are two HDMI audio/video outputs and one COAX audio output. Video can be output on one or both
of the HDMI outputs. Audio can be output on the HDMI outputs and/or the COAX output.
Additional connections are provided for LVTTL command input (38 KHz IR format), RS232 command output,
RS232 command input/update, plus the 5 VDC power input.
These connections are described on the following page.
HDMI Connections
2 HDMI SD/HD Outputs. HDMI1 supports video resolutions up to 1080p60 with support for
HDMI 1.4a audio formats.
4 HDMI SD/HD Inputs. Supports resolutions up to 1080p60
Note: CEC bit pass-through is connected from the HDMI inputs to HDMI Output 1.
Analog Video Input Connections
2 Component / RGsB Inputs / RGBcvS. Supports resolutions up to 720p60, 1080i30. Input 8
can be used as an RGBHV Input. In this Mode VSync uses Input 9, and HSync uses Input
10. Each of these inputs can support RGBcvS. For RGBcvS, an input is combined with the
adjacent composite video input (i.e. Input 8 + cvS on Input 10).
2 S-video Inputs. Supports NTSC, PAL and SECAM.
2 Composite Inputs. Supports NTSC, PAL and SECAM.