Martin Archery Martin Compound - Manual (Page 7)

7
Basic Setup
Your new Martin bow takes little setup to get started shooting. Please read and
familiarize yourself with these starting procedures before shooting. Many of these
procedures may have been completed by your authorized Martin dealer. After
completing these simple steps, you will be more accurate and will have greater success
from the start. A careful and thorough initial setup will make the tuning process much easier.
Quick Arrow Rest and Nock Placement
You can quickly and easily set the position of your rest
and nock point using the rest mount holes in your bow. Your
rest should sit level with the two rest mount holes, or lock
mount of your bow. (See graphic) When the rest placement
is correct, you can begin placing the nock set. Place a nock
loosely on the string and nock an arrow. Visually align the
arrow level with or slightly tail high of the rest mount holes.
When the correct height is set, crimp the nock set into place.
This will give you a good starting point to begin tuning your bow.
Measuring Draw Length
When your bow is at full draw, the apex of
the string should be near the corner of your
mouth.
Draw length can easily be measured from the
apex of the string at full draw to the pivot point
of the grip. From that measurement add 1 ¾”
and you will have the A.M.O. standard draw
length. All Martin Bows are adjustable with the
use of modules. Refer to the section that cov-
ers your specific cam style for instructions on
adjusting draw length.
Arrow Speed and String Accessories
Certain bowstring accessories including D-loops, string silencers, and peep sights, can
reduce arrow speed by as much 10-15 fps.
Changing Draw Weight
Martin bows have a fifteen pound draw weight range. Using a 3/16” allen wrench ; you
will turn the limb bolts clockwise to add weight and turn counter clockwise to reduce weight.
One complete turn on each limb bolt provides about 3 pounds of adjustment.
TIP: Mark a line on each limb bolt in white-out or white paint marker to make it easier to
keep track of how far you are turning each bolt.
Note: Do not shoot your bow with the limb bolts more than 5 turns out from the riser.
Replacing The Strings
Should your string need replacing, it is best to go to your Martin dealer and have it done
by experts. Always be sure that the string you replace it with is of the correct length and
material for your bow. We recommend using Martin Hammerhead bow strings. String wear
is not covered by warranty.