Peachtree Audio deepblue2 - Manual (Page 7)

VOL
VOL
BASS
+
BASS _
AUX OPT
1
2
5 6
4
3
8 7
9
7
Remote
B
C
D
E
On / Standby: Push and release to toggle between power on and standby modes.
The current input LED will light for 10 seconds after the unit is toggled on.
VOL
^ : Push and release to increase the volume level by 1 step. Push and hold for
more than 1 second to increase the volume level by multiple steps. The volume will
continue increasing until you release the button or achieve the maximum volume
level.
VOL
^ : Push and release to decrease the volume level by 1 step. Push and hold
for more than 1 second to decrease the volume level by multiple steps. The
volume will continue decreasing until you release the button or achieve the
minimum volume level.
Mute Symbol: Push and release to toggle audio muting on and off. The five LEDs
will flash white while audio is muted.
Notes: The blue LEDs indicate the volume level for 10 seconds after a volume
button is released. Each LED represents 20% of the volume range.
^
F BASS +: Push and release to increase the bass level by 1 step. Push and hold for more
than 1 second to increase the bass level by multiple steps. The bass will continue
increasing until you release the button or achieve the maximum bass level.
G BASS -: Push and release to decrease the bass level by 1 step. Push and hold for more
than 1 second to decrease the bass level by multiple steps. The bass will continue decreasing
until you release the button or achieve the minimum bass level.
Notes: The first press of the BASS+ or BASS-
buttons will display the current setting via
the white LEDs. Subsequent presses within
10 seconds will adjust the bass setting. Each
white LED represents 20% of the bass range.
The lowest bass setting (1) is indicated by the
left-most LED being lit 50%. The highest setting
(10) is indicated by all the LEDs being fully lit.
H AUX: Push and release to select the AUX
input on the rear panel. The blue LED will
light for 10 seconds indicating the AUX
input is selected. Note: When the unit is in
standby mode, this will also turn the unit on.
I OPT: Push and release to select the OPT
input on the rear panel. The white LED will
light for 10 seconds indicating the OPT
input is selected. Note: When the unit is in
standby mode, this will also turn the unit on.
J Bluetooth Symbol: Push and release
to select the Bluetooth input. The blue
LED will light for 10 seconds indicating the
input is selected. Note: deepblue 2 will pair
with up to 5 Bluetooth devices. After they
are paired, pressing and releasing the
Bluetooth button will switch between
them.