Portable Winch Gas-powered pulling/lifting winch PCH1000 - Manual (Page 41)

41
Schedule I. Periodic inspection log sheet (every 100 hours of operation )
WINCH SERIAL NUMBER:
(over 600 hours, print more
of these pages at
www.portablewinch.com)
INITIAL
INSPECTION
#1 #2 #3 #4 #5 #6
DATE
HOUR METER READING
YES / NO
GEARBOX
Warning labels present and
legible?
Any leaks found?
Gearbox oil level is OK
All screws and bolts are tight
Anchor hooks - no cracks,
clasp is working
Shaft end-play less than
0.5 mm (0.020'')
Drum keyway is tight
Capstan shaft & seal area are
clean
Rope entry pulley (brass
pulley) rotating, no flat section
Cracks in housing found?
ROPE GRABBING
SYSTEM/WINCH CONTROLS
Main plate pivots freely
Pivot bolt is tight
No excessive wear on pivoting
parts
Throttle control operational
Clutch rotor is tight, no cracks
or uneven wear
Clutch drum is tight, turns
freely, wall is >2 mm
ENGINE
Spark plug is clean with proper
gap
Idle speed is adjusted
Valve clearance within specs
Fuel tank/filter are clean
Spark arrestor is clean
Oil is new and level is good
Air filter is clean
Figure 37 Figure 38