TrakPower DPS 12V 25A Racing Power Supply - Manual (Page 5)

5
Connecting the TrakPower VR-1 Charger
Located on the top of the power supply is a set of 12V DC banana terminals.
These terminals are designed for use with the TrakPower VR-1 charger. A set
of dual banana plugs is included with the charger to mate the charger and
power supply together. See pictures below for installation:
VR-1 Charger
DPS Power Supply
Safety Features
The TrakPower DPS power supply has a 25 amp solid-state current limiter for
overload protection, plus short circuit protection. If either of these conditions
occur, disconnect the supply from the AC input, wait approximately 15 seconds
to allow the device to reset, and then re-connect to the AC input.
A built-in cooling fan keeps electronics cool to help maintain optimum
effi ciency and extend the life of the power supply.
WARNING:
Do not block the air vents on the power supply. Make sure there
is ample room for air to enter and leave the power supply so heat can dissipate
effi ciently.