VAC Renaissance Mk II Preamplifier - Manual (Page 4)

3
UNPACKING & ASSEMBLY
The Renaissance Mk II is shipped with the vacuum tubes installed.
Connect the DC cable from the power supply.
Tighten the two retaining screws.
NOTE: Do not plug the power supply into the wall outlet unless it is connected to the
audio chassis.
Connect the iVAC data communications cable to an associated Phi Power Amplifier if
appropriate. This allows the preamplifier to control power on, power off, and logo
illumination intensity.
Alternatively, the 12 volt trigger outputs may be used to switch on/off some brands of
power amplifiers.