Vortech 1986-1993 Ford 5.0L Mustang User Manual
Page 12
9"
1" HEATER
HOSE
1" HEATER HOSE
BYPASS
VALVE
2-1/2"
CONNECT TO
MANIFOLD VACUUM
VIEW FROM
PASSENGER SIDE
AFTERCOOLER
6.
Aftercooler and Idle Air Bypass Controller Mounting
A. With the supplied gasket and 1/4-20 hardware,
mount the idle air controller to the aftercooler
as shown.
B. Cut the supplied 1” hose into 2-1/2” and 9”
lengths and attach to the supercharger air
bypass valve (See graphic). Secure the
assembly to the air inlet elbow with #16 clamps.
C. Remove the silicone sleeves and clamps from
the original discharge tube.
D. Reinstall the 2-3/4” diameter silicone sleeve
onto the supercharger discharge tube, slide
the sleeve back as far as possible, leaving the
two #44 hose clamps loose.
E. Slide the 3” diameter silicone sleeve onto the
aftercooler discharge, leaving the two #48 hose
clamps loose.
F. Secure the 1” supercharger air bypass hose
assembly to the plastic 1” fitting on to
aftercooler discharge.
G. Slide aftercooler into the position and secure
the silicone sleeves and clamps.
H. Secure the 5/8” hose with the #8 hose clamp
onto the 5/8” x 90
° fitting located on the
Maxflow
®
Power Cooler™.
7
© 1997, 2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
24JAN00 V 1.0