Starting the engine – Volvo 2005 C70 User Manual

Page 70

Advertising
background image

64

Starting and stopping

1. Fasten the seat belt.

WARNING!

Before starting, check that the seat, steering

wheel and mirrors are adjusted properly.

Make sure the brake pedal can be depressed

completely. Move the seat closer if

necessary. Refer to section “front seats”.

2. Apply the parking brake, if not already set.

The gear selector (automatic transmission)

is locked in the (P)ark position (SHIFT-

LOCK).

Manual transmission: the clutch must be

fully depressed.

3.Without touching the accelerator pedal,

turn the ignition key to the starting posi-

tion*. Allow the starter to operate for up to

10 seconds. Release the key as soon as the

engine starts. If the engine fails to start,

repeat step 3.

For cold starts at altitudes above 6000 ft

(1800 meters), depress the accelerator pedal

halfway and turn the key to the starting

position. Release the pedal slowly when the

engine starts.

Starting the engine

4. To release the gear selector from the (P)ark

position (automatic transmission), the

ignition key must be in position II and the

brake pedal must be depressed. See page

106 for instructions on manually releas-

ing the SHIFTLOCK system.

NOTE: (Automatic transmission only)

Your car is equipped with a KEYLOCK

system. When the engine is switched off, the

gear selector must be in the (P)ark position

before the starting key can be removed from

the ignition switch.
5. Select the desired gear. The gear engages

after a slight delay (automatic transmission)

which is especially noticeable when

selecting R.

CAUTION: (Automatic transmission only)

The engine should be idling; never

accelerate until after you feel the gear

engage! Too-rapid acceleration immediately

after selecting a gear will cause harsh

engagement and premature transmission

wear.

NOTE: Selecting P or N (automatic

transmission) when idling at a standstill for

prolonged periods of time will help prevent

overheating of transmission oil.

* If the key is left in the Drive position

(position II) for more than 30 seconds, it must

be turned to position 0 and then turned to the

Start position (position III) again in order to

start the car. See page 21 for ignition key

positions.

WARNING!

Always place the gear selector (automatic

transmission) in Park and apply the parking

brake before leaving the vehicle. Never

leave the car unattended with the engine

running.
Always open the garage doors fully before

starting the engine inside a garage to ensure

adequate ventilation. The exhaust gases

contain carbon monoxide, which is invisible

and odorless but very poisonous.

CAUTION: Never race the engine

immediately after starting. Oil flow may

not reach some lubricating points fast

enough to prevent engine damage.

Do not race the engine just prior to

switching off!

Advertising