DeLorme GPS2058 - Manual (Page 3)

Rev. 1.3 Page 3 of 8 4/25/2008
http://www.delorme.com/gpsmodules
Kit Contents
Your GPS2058EVK kit contains the following:
1. GPS2058 evaluation board with module, in plastic case
2. Active
antenna
3. USB cable
4. 120/220V wall adapter
5. 12V auto adapter
6. Street Atlas USA® 2008 DVD
Getting Started – Quick Guide
1) Verify all kit contents are present.
2) Install Evaluation kit demonstration software (downloaded with this document)
3) Plug the antenna into the antenna connector. Ensure you have a sky view with the antenna for proper
signal reception.
4) Connect the USB cable between the evaluation kit and the PC.
5) Turn on the evaluation kit power. The right LED shows green.
6) The left LED should be flashing red once per second while acquiring a signal.
7) An initial fix should be achieved in approximately 1 minute or less. It may take longer if the antenna view of
the sky is blocked. If no fix is achieved, refer to the troubleshooting section. A fix is achieved when the
Status LED alternates between green and yellow once per second.