ILUMINARC Ilumicode™ Addresser - Manual (Page 11)

Operation
Ilumicode V 2.21 User Manual Rev. 3 7
4. Operation
When turned on,
the Ilumicode V
2.21 display
shows “VER 2.21”.
The Ilumicode V
2.21 has a timer
that turns the unit
off after 60 seconds of
inactivity.
The LCD display
on the Ilumicode
V 2.21 shows the
Ilumicode’s last
sent setting, not the
current setting on the
product.
Make sure you
have connected
the Ilumicode V
2.21 to the
product(s) before starting
programming.
To change the
DMX address of a
single product,
make sure that
there is no other product
connected to the DMX
cable.
Compatible
ILUMINARC®
products do not
light up when they do not
receive DMX or Ilumicode
signals, unless they are in
STATIC mode
Some
personalities on
this list may not
apply to your
ILUMINARC® product.
Consult the product’s
manual for more
information.
Ilumicode Panel Description
Button Function
<MENU> Exits from the current menu or function.
<ENTER>
Enables the currently displayed menu or sets the
currently selected value into the selected
function.
<UP>
Navigates upwards through the menu list and
increases the numeric value when in a function.
<DOWN>
Navigates downwards through the menu list and
decreases the numeric value when in a function.
<POWER>
Turns the unit on. The unit will turn off
automatically after 30 seconds of inactivity.
Product Compatibility
The Ilumicode V 2.21 contains all the parameters for all the compatible ILUMINARC®
products it can control. Therefore, consult the corresponding product’s user manual to
determine which parameters on the Ilumicode V 2.21 apply to that specific product.
Programming
Carry out all the programming procedures indicated below from the control panel. Refer to
the
Menu Map section to learn how the menu options relate to each other.
Use <ENTER> and <MENU> to change levels in the Menu Map, moving right and left
respectively. Use <UP> and <DOWN> to move vertically within the Menu Map.
DMX Personality
1. Go to PERS and select any DMX personality.
2. Make sure to rearrange the DMX addresses of all products in the current DMX
universe to avoid address overlapping.
DMX Starting Address
1. Go to DMX.
2. Select a starting DMX address (001~512).
3. Press <ENTER> to send the new DMX address to the product. The display will show
“SEND…”
Dmx Values
Refer to the compatible ILUMINARC® product’s manual for the DMX Values that
correspond to that particular product.